| alt.autos.toyota alt.autos.toyota newsgroup | 
11-08-2006, 03:54 PM
| | | Help! RAV4 heater fan '96 RAV4 AC/H fan has quit after one setting has been dead for a while. My
question: is it the fan motor, is the relay below the fan for the fan or is
it the switch that is bad? I figure that you folks have the conventional
wisdom and experience with this problem. I did push on all the connectors
and pulled and pushed that relay, the fan started and ran for 30 minutes.
Thanks in advance. - Allen | 
11-08-2006, 03:54 PM
| | | Re: Help! RAV4 heater fan
"bushman" <askme@askme.com> wrote in message
news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
> '96 RAV4 AC/H fan has quit after one setting has been dead for a while. My
> question: is it the fan motor, is the relay below the fan for the fan or
> is it the switch that is bad? I figure that you folks have the
> conventional wisdom and experience with this problem. I did push on all
> the connectors and pulled and pushed that relay, the fan started and ran
> for 30 minutes. Thanks in advance. - Allen
Besides the items you listed, other possible causes are the resistor pack
and the wiring.
If you want to properly identify the problem, you should invest in a
volt/ohm meter if you do not already have one.
If there is another relay identical to the fan relay, you can try swapping
them to see if the swapped item starts acting up, or you can pull the relay,
apply 12 volts to the control voltage, and see if there is continuity
through the switched side. If the relay is passing power, then check for
power going into and out of the resistor pack. I suspect that the resistor
pack is the problem.
--
Ray O
(correct punctuation to reply) | 
11-08-2006, 03:54 PM
| | | Re: Help! RAV4 heater fan OK I will poke around with the tester. Where is the resistor pack?
-Allen
"Ray O" <rokigawaATtristarassociatesDOTcom> wrote in message
news:5095f$4550e626$44a4a10d$6699@msgid.meganewsse rvers.com...
>
> "bushman" <askme@askme.com> wrote in message
> news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
>> '96 RAV4 AC/H fan has quit after one setting has been dead for a while.
>> My question: is it the fan motor, is the relay below the fan for the fan
>> or is it the switch that is bad? I figure that you folks have the
>> conventional wisdom and experience with this problem. I did push on all
>> the connectors and pulled and pushed that relay, the fan started and ran
>> for 30 minutes. Thanks in advance. - Allen
> Besides the items you listed, other possible causes are the resistor pack
> and the wiring.
>
> If you want to properly identify the problem, you should invest in a
> volt/ohm meter if you do not already have one.
>
> If there is another relay identical to the fan relay, you can try swapping
> them to see if the swapped item starts acting up, or you can pull the
> relay, apply 12 volts to the control voltage, and see if there is
> continuity through the switched side. If the relay is passing power,
> then check for power going into and out of the resistor pack. I suspect
> that the resistor pack is the problem.
> --
>
> Ray O
> (correct punctuation to reply)
> | 
11-08-2006, 03:54 PM
| | | Re: Help! RAV4 heater fan In the fan housing, I'll guess.
Asbjørn
"bushman" <askme@askme.com> wrote in message
news:8tj4h.6628$sv1.690@tornado.tampabay.rr.com...
> OK I will poke around with the tester. Where is the resistor pack?
> -Allen
>
> "Ray O" <rokigawaATtristarassociatesDOTcom> wrote in message
> news:5095f$4550e626$44a4a10d$6699@msgid.meganewsse rvers.com...
>>
>> "bushman" <askme@askme.com> wrote in message
>> news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
>>> '96 RAV4 AC/H fan has quit after one setting has been dead for a while.
>>> My question: is it the fan motor, is the relay below the fan for the fan
>>> or is it the switch that is bad? I figure that you folks have the
>>> conventional wisdom and experience with this problem. I did push on all
>>> the connectors and pulled and pushed that relay, the fan started and ran
>>> for 30 minutes. Thanks in advance. - Allen
>> Besides the items you listed, other possible causes are the resistor pack
>> and the wiring.
>>
>> If you want to properly identify the problem, you should invest in a
>> volt/ohm meter if you do not already have one.
>>
>> If there is another relay identical to the fan relay, you can try
>> swapping them to see if the swapped item starts acting up, or you can
>> pull the relay, apply 12 volts to the control voltage, and see if there
>> is continuity through the switched side. If the relay is passing power,
>> then check for power going into and out of the resistor pack. I suspect
>> that the resistor pack is the problem.
>> --
>>
>> Ray O
>> (correct punctuation to reply)
>>
>
> | 
11-08-2006, 03:54 PM
| | | Re: Help! RAV4 heater fan That is the it was on my FX. Had to replace the fan. Thanks. - Allen
"Asbjørn" <asbjust@frisurf.no> wrote in message
news:epudnVu6hOPQT8zYRVnzvQ@telenor.com...
> In the fan housing, I'll guess.
>
> Asbjørn
>
>
> "bushman" <askme@askme.com> wrote in message
> news:8tj4h.6628$sv1.690@tornado.tampabay.rr.com...
>> OK I will poke around with the tester. Where is the resistor pack?
>> -Allen
>>
>> "Ray O" <rokigawaATtristarassociatesDOTcom> wrote in message
>> news:5095f$4550e626$44a4a10d$6699@msgid.meganewsse rvers.com...
>>>
>>> "bushman" <askme@askme.com> wrote in message
>>> news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
>>>> '96 RAV4 AC/H fan has quit after one setting has been dead for a while.
>>>> My question: is it the fan motor, is the relay below the fan for the
>>>> fan or is it the switch that is bad? I figure that you folks have the
>>>> conventional wisdom and experience with this problem. I did push on all
>>>> the connectors and pulled and pushed that relay, the fan started and
>>>> ran for 30 minutes. Thanks in advance. - Allen
>>> Besides the items you listed, other possible causes are the resistor
>>> pack and the wiring.
>>>
>>> If you want to properly identify the problem, you should invest in a
>>> volt/ohm meter if you do not already have one.
>>>
>>> If there is another relay identical to the fan relay, you can try
>>> swapping them to see if the swapped item starts acting up, or you can
>>> pull the relay, apply 12 volts to the control voltage, and see if there
>>> is continuity through the switched side. If the relay is passing
>>> power, then check for power going into and out of the resistor pack. I
>>> suspect that the resistor pack is the problem.
>>> --
>>>
>>> Ray O
>>> (correct punctuation to reply)
>>>
>>
>>
>
> | 
11-08-2006, 11:17 PM
| | | Re: Help! RAV4 heater fan I do not know for sure about the RAV4 (I have not got mine yet),
but on my former Corolla I unscrewed the resistor pack from the fan housing
and repaired the broken resistors with crimping cable connectors
because normal soldering will probably melt.
Asbjørn
"bushman" <askme@askme.com> wrote in message
news:YAm4h.12102$q45.8738@tornado.tampabay.rr.com. ..
> That is the it was on my FX. Had to replace the fan. Thanks. - Allen
>
> "Asbjørn" <asbjust@frisurf.no> wrote in message
> news:epudnVu6hOPQT8zYRVnzvQ@telenor.com...
>> In the fan housing, I'll guess.
>>
>> Asbjørn
>>
>>
>> "bushman" <askme@askme.com> wrote in message
>> news:8tj4h.6628$sv1.690@tornado.tampabay.rr.com...
>>> OK I will poke around with the tester. Where is the resistor pack?
>>> -Allen
>>>
>>> "Ray O" <rokigawaATtristarassociatesDOTcom> wrote in message
>>> news:5095f$4550e626$44a4a10d$6699@msgid.meganewsse rvers.com...
>>>>
>>>> "bushman" <askme@askme.com> wrote in message
>>>> news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
>>>>> '96 RAV4 AC/H fan has quit after one setting has been dead for a
>>>>> while. My question: is it the fan motor, is the relay below the fan
>>>>> for the fan or is it the switch that is bad? I figure that you folks
>>>>> have the conventional wisdom and experience with this problem. I did
>>>>> push on all the connectors and pulled and pushed that relay, the fan
>>>>> started and ran for 30 minutes. Thanks in advance. - Allen
>>>> Besides the items you listed, other possible causes are the resistor
>>>> pack and the wiring.
>>>>
>>>> If you want to properly identify the problem, you should invest in a
>>>> volt/ohm meter if you do not already have one.
>>>>
>>>> If there is another relay identical to the fan relay, you can try
>>>> swapping them to see if the swapped item starts acting up, or you can
>>>> pull the relay, apply 12 volts to the control voltage, and see if there
>>>> is continuity through the switched side. If the relay is passing
>>>> power, then check for power going into and out of the resistor pack. I
>>>> suspect that the resistor pack is the problem.
>>>> --
>>>>
>>>> Ray O
>>>> (correct punctuation to reply)
>>>>
>>>
>>>
>>
>>
>
> | 
11-08-2006, 11:17 PM
| | | Re: Help! RAV4 heater fan
"bushman" <askme@askme.com> wrote in message
news:8tj4h.6628$sv1.690@tornado.tampabay.rr.com...
> OK I will poke around with the tester. Where is the resistor pack?
> -Allen
>
On every car I've seen, the resistor pack that controls blower fan speed is
in or in front of the blower.
--
Ray O
(correct punctuation to reply)
> "Ray O" <rokigawaATtristarassociatesDOTcom> wrote in message
> news:5095f$4550e626$44a4a10d$6699@msgid.meganewsse rvers.com...
>>
>> "bushman" <askme@askme.com> wrote in message
>> news:Qu54h.4304$Bl1.974@tornado.tampabay.rr.com...
>>> '96 RAV4 AC/H fan has quit after one setting has been dead for a while.
>>> My question: is it the fan motor, is the relay below the fan for the fan
>>> or is it the switch that is bad? I figure that you folks have the
>>> conventional wisdom and experience with this problem. I did push on all
>>> the connectors and pulled and pushed that relay, the fan started and ran
>>> for 30 minutes. Thanks in advance. - Allen
>> Besides the items you listed, other possible causes are the resistor pack
>> and the wiring.
>>
>> If you want to properly identify the problem, you should invest in a
>> volt/ohm meter if you do not already have one.
>>
>> If there is another relay identical to the fan relay, you can try
>> swapping them to see if the swapped item starts acting up, or you can
>> pull the relay, apply 12 volts to the control voltage, and see if there
>> is continuity through the switched side. If the relay is passing power,
>> then check for power going into and out of the resistor pack. I suspect
>> that the resistor pack is the problem.
>> --
>>
>> Ray O
>> (correct punctuation to reply)
>>
>
> | | Thread Tools | | | | Display Modes | Linear Mode |
Posting Rules
| You may not post new threads You may not post replies You may not post attachments You may not edit your posts HTML code is Off | | | All times are GMT. The time now is 06:34 AM.
|