"Hein" <t4a@mukuyu.org> wrote in message
news:9a9cdc1d-5265-49df-a5c3-4a54406a9207@e2g2000hsh.googlegroups.com...
> We are building a medical boat for use as a mobile clinic on the
> Zambezi River in Zambia (http://mukuyu.org/index.php?
> option=com_content&view=article&id=176&Itemid=14), and we're using a
> 2L diesel engine to power it. We need to get a bell housing made for
> it, but we a technical drawing of the back end that shows where the
> holes sit on the engine in relation to dead center of the flywheel.
>
> Does anyone have any idea where I can find this? I've searched the net
> for ages and Toyota can't help me.

I have never seen technical drawings for bell housing measurements. Your
best bet is to trace the housing or take an existing bell housing and modify
it for your use.

Good luck!

--

Ray O
(correct punctuation to reply)